PMID- 37443450 OWN - NLM STAT- PubMed-not-MEDLINE LR - 20230727 IS - 1944-8252 (Electronic) IS - 1944-8244 (Linking) VI - 15 IP - 29 DP - 2023 Jul 26 TI - Regulating the Crystallization Growth of Sn-Pb Mixed Perovskites Using the 2D Perovskite (4-AMP)PbI(4) Substrate for High-Efficiency and Stable Solar Cells. PG - 34862-34873 LID - 10.1021/acsami.3c05277 [doi] AB - Sn-Pb mixed perovskite solar cells (PSCs) are developing rapidly and making great progress due to their environmentally friendly advantages. High-crystalline quality perovskite films are essential for obtaining high-efficiency and -stability PSCs. Here, the DJ-phase two-dimensional (2D) perovskite (4-AMP)PbI(4) (4-AMP is 4-(aminomethyl) piperidine) was used as a substrate to regulate the crystallization growth of the Sn-Pb mixed perovskite for preparing high-quality perovskite films, and the regulation mechanism was analyzed in detail. The results indicate that the suitable amount of the 2D perovskite substrate is favorable for the formation of PbI(2)/SnI(2) films with wide intergranular gaps and vertical distribution grain boundaries. Moreover, the suitable hydrophobicity of the PbI(2)/SnI(2) film made on the 2D perovskite substrate also provides a better template for regulating the formation and dissolution of prophase perovskite capping. In addition, the 4-AMP cations from the collapsed 2D perovskite substrate can diffuse into PbI(2)/SnI(2) films and interact with PbI(2) to form the intermediate (4-AMP)-PbI(2)-(4-AMP) and with SnI(2) to form the 2D perovskite (4-AMP)SnI(4). All of these promote the diffusion of FAI/MAI molecules and decrease the crystallization growth rate of the Sn-Pb perovskite and thus increase the conversion levels of the perovskite phase and improve the crystallization orientation and quality of the perovskite, which helps mitigate the erosion of water and oxygen. In addition, the 2D perovskite used as a substrate can passivate the buried interface defects and improve the interfacial contact. Moreover, the diffusion behavior of 4-AMP cations regulates the perovskite energy levels, which match more with those of the electron transport layer. As a result, the champion device made on the (4-AMP)PbI(4) substrate acquires a power conversion efficiency (PCE) of 17.7% with an open-circuit voltage (V(oc)) of 0.806 V, a short-circuit current density (J(sc)) of 28.97 mA cm(-2), and a fill factor (FF) of 75.86%, far exceeding those of the control device. Meanwhile, the unencapsulated PSCs modified with 4-AH retain above 70% of the initial efficiency value after storage for 1200 h in N(2) at room temperature and about 25% of its initial efficiency after exposure to air for nearly 300 h with RH = 30 +/- 10% at room temperature, while the control device has only 30% of the initial efficiency and near-zero efficiency at the same conditions. FAU - Ma, Yufei AU - Ma Y AD - College of Photoelectric Engineering, Key Lab of Advanced Transducers and Intelligent Control System, Taiyuan University of Technology, Taiyuan 030024, China. AD - Shanxi-Zheda Institute of Advanced Materials and Chemical Engineering, Taiyuan 030000, China. FAU - Zheng, Fei AU - Zheng F AD - College of Photoelectric Engineering, Key Lab of Advanced Transducers and Intelligent Control System, Taiyuan University of Technology, Taiyuan 030024, China. AD - Shanxi-Zheda Institute of Advanced Materials and Chemical Engineering, Taiyuan 030000, China. FAU - Li, Shiqi AU - Li S AUID- ORCID: 0009-0007-6490-338X AD - College of Photoelectric Engineering, Key Lab of Advanced Transducers and Intelligent Control System, Taiyuan University of Technology, Taiyuan 030024, China. AD - Shanxi-Zheda Institute of Advanced Materials and Chemical Engineering, Taiyuan 030000, China. FAU - Liu, Yifan AU - Liu Y AD - College of Photoelectric Engineering, Key Lab of Advanced Transducers and Intelligent Control System, Taiyuan University of Technology, Taiyuan 030024, China. AD - Shanxi-Zheda Institute of Advanced Materials and Chemical Engineering, Taiyuan 030000, China. FAU - Ren, Jingkun AU - Ren J AD - College of Photoelectric Engineering, Key Lab of Advanced Transducers and Intelligent Control System, Taiyuan University of Technology, Taiyuan 030024, China. AD - Shanxi-Zheda Institute of Advanced Materials and Chemical Engineering, Taiyuan 030000, China. FAU - Wu, Yukun AU - Wu Y AD - College of Photoelectric Engineering, Key Lab of Advanced Transducers and Intelligent Control System, Taiyuan University of Technology, Taiyuan 030024, China. AD - Shanxi-Zheda Institute of Advanced Materials and Chemical Engineering, Taiyuan 030000, China. FAU - Sun, Qinjun AU - Sun Q AUID- ORCID: 0000-0001-9929-0308 AD - College of Photoelectric Engineering, Key Lab of Advanced Transducers and Intelligent Control System, Taiyuan University of Technology, Taiyuan 030024, China. AD - Shanxi-Zheda Institute of Advanced Materials and Chemical Engineering, Taiyuan 030000, China. FAU - Hao, Yuying AU - Hao Y AUID- ORCID: 0000-0002-9691-7109 AD - College of Photoelectric Engineering, Key Lab of Advanced Transducers and Intelligent Control System, Taiyuan University of Technology, Taiyuan 030024, China. AD - Shanxi-Zheda Institute of Advanced Materials and Chemical Engineering, Taiyuan 030000, China. LA - eng PT - Journal Article DEP - 20230713 PL - United States TA - ACS Appl Mater Interfaces JT - ACS applied materials & interfaces JID - 101504991 SB - IM OTO - NOTNLM OT - 2D perovskite substrate OT - Sn-Pb mixed perovskite OT - crystallization regulation OT - interfacial passivation OT - solar cells EDAT- 2023/07/14 13:07 MHDA- 2023/07/14 13:08 CRDT- 2023/07/14 00:42 PHST- 2023/07/14 13:08 [medline] PHST- 2023/07/14 13:07 [pubmed] PHST- 2023/07/14 00:42 [entrez] AID - 10.1021/acsami.3c05277 [doi] PST - ppublish SO - ACS Appl Mater Interfaces. 2023 Jul 26;15(29):34862-34873. doi: 10.1021/acsami.3c05277. Epub 2023 Jul 13.